Skye I.T. Services

16/06/2026

After many many years I've finally set up a Trustpilot account for Skye IT Services. So if I've ever installed a dish, network or CCTV that hasn't failed yet please do leave me a wee review.

Your insights can help this company and all of your fellow shoppers.

28/04/2026

A day in the sunshine in Elgol. This time working on a 3 house fibre dome.

24/04/2026

Took the drone with me today as it was that type of day. Working outside on Skye in the sunshine. I don’t think much can beat it. Ok. Not working on Skye in the sunshine.

17/03/2026

I call it eco mode but it should actually be called robbing bastards mode…
Reducing oil usage by 40% and hopefully still warm enough.

20/02/2026

3D printed some flexible and waterproof grommets for the Starlink Gen3. 95% of my installs don’t use the Starlink cable (unless it’s a very short run) so these grommets are needed to stop water ingress.

09/02/2026

Free Starlink install vs professional - what's the difference?
The free install gets you online, but there are some important limitations for Highland properties – especially in exposed, wind-affected areas.
I've written up a comparison to help you decide which approach is right for your location and needs. No sales pitch, just honest information about what each option covers.
Neither is wrong – it just depends on your property and how critical reliable connectivity is to you.
Read more here -

Starlink installation in the Scottish Highlands and Islands. Compare free standard installation vs professional installs built for West Coast wind, salt air, and exposed locations. Expert advice, no obligation quotes.

07/02/2026

Nice to have a page dedicated to showcasing Elgol and its sights. If you want to see some nice (and not so nice) views give them a follow.

We reached 500 followers yesterday! 🎉 So a little thank you is in order to say thanks for following this page.

We hope you keep enjoying the Daily Elgol Views and we’ll keep posting information about news and announcements about Elgol and its local businesses.

If you have any suggestions about anything else you’d like to see here, please let us know!

04/02/2026

Printing my own Nanostation mounts using ASA filament. 280C extrusion temp and 110C bed temp. Watching the lights dim

03/02/2026

When I was supposed to be working…