02/08/2022
Milling the teeth that allow you to cut 16' per minute 12" deep and leave a clean trench.
Originally we did one at a time, then two, then four, now 24 and soon to be on two milling machines at the same time doing 48.
Originally it took about 1.5 hours of attended milling to cut enough teeth for a blade, now I am down to 24 minutes and we run unattended.
At least now milling is not the choke point. Not complaining, I am almost always sold out of blades.
Thanks to some of you fine folks.
We went from cutting one at a time, to two, to four now we are doing 24 and soon to be 24 on two machines at once.
